mintyLEDs

Spice up your arcade buttons with these 2-pin Neopixel-compatible LEDs! A drop-in replacement for existing LEDs, these fit most switches.

Compatible with:
- Chinese switches
- Sanwa switches (spade connector)
- Samducksa
NOT compatible with 4-pin JST connector Sanwa switches. May be possible if you trim the LEDs short

Voltage: 5V
Reverse voltage protection: Yes. Reverse LED if it does not light.
Over-voltage protection: No! 5V only.
Current: Max 72mA full brightness white
Protocol: +5V power, Neopixel signal on Gnd. Low level must sink current. High level signal may be open (ie: MOSFET driver) or +5V (eg: Arduino GPIO pin).